 |
 |
18 of 35 |  |
 |
 |
1.
Slide the float shaft out of the
float
lever bracket and remove float and
lever assembly.
Figure 15. Removing Choke Lever Clamp
Screw
F.
DISASSEMBLY - MAIN BODY AS
SEMBLY ALL 2110 SERIES
Figure 14. Removing Float Shaft
and Float Assembly
2. Remove the fuel inlet needle,
float
spring and float spring retainers.
3. Using Kent-Moore Tool No. 10-183,
remove the fuel inlet valve seat
and gasket. Dis
card gasket.
NOTE
The fuel inlet needle and the seat
is a matched
assembly. This set is not to be
broken. Re
placements should be made only with
a new
factory-matched set.
4. Remove the choke lever clamp
screw,
and nut. Slide the choke lever clamp
off the choke
shaft. (Note position of choke lever;
will assist
in reassembly.)
5. Remove the choke wire clamp screw
and nut. Remove choke wire bracket
screw and
lockwasher and remove the throttle
lever spring
bracket. Lift choke wire bracket
assembly from
choke shaft.
6. Remove the two choke plate screws
and remove the choke plate.
7. Remove choke shaft. (Note position
of screw hole for correct reassembly.)
8. Remove fuel inlet connection
and
the governor line connection.
The following list contains all
parts to
be removed in disassembling the
main body as
sembly. During disassembly discard
all gaskets,
also all parts which have replacements
in the
Master Repair Kit.
Figure 16. Disassembly - Main Body
Assembly
